ESAS · Question Bank

Laws, Codes & Ethics

98 questions · page 1 of 5. Answer in your head first, then check the solution.

TypeAll 98Problem solvingObjective 98
DifficultyAll 98Easy 98MediumHard
#1📘 EE Pocket Reviewer RojasEasy
The unit lighting for a dwelling unit expressed in watts per square meter shall be
A8 watts
B26 watts
C24 watts
D40 watts
#2📘 EE Pocket Reviewer RojasEasy
For REE examination, the passing general average is 70% provided there is no grade below ____ in any of the 3 subjects.
A50%
B60%
C65%
D40%
#3📘 EE Pocket Reviewer RojasEasy
Any equipment which produces, modifies, regulates, or controls the supply of electric energy is the ____.
AElectric supply equipment
BTransformer
CSubstation
DGenerator set
#4📘 EE Pocket Reviewer RojasEasy
RA 7920, Rule 2 (d) defines?
ACHED
BCommission
CBoard of EE
DTESDA
#5📘 EE Pocket Reviewer RojasEasy
What is the article V of Code of Ethics for Electrical Engineers?
AProfessional life
BPenal provisions
CEffectively
DRelations with Client and Employer
#6📘 EE Pocket Reviewer RojasEasy
RA 9136 has four sectors, which of the following is NOT included?
ASupply
BDistribution
CGeneration
DSystem operation
#7📘 EE Pocket Reviewer RojasEasy
What is PDC in EPIRA stands for
APhilippine Distribution Commission
BPhilippine Distribution Code
CPhilippine Distribution Committee
DPhilippine Distribution Coordination
#8📘 EE Pocket Reviewer RojasEasy
A carwash area is classified as
AWet location
BDry location
CDamp location
DMoist location
#9📘 EE Pocket Reviewer RojasEasy
Motors must be labelled with the following: nameplate rating, manufacturer’s name and etc. This is
AManufacturing rule
BConstruction rule
CWiring design rule
DInstallation rule
#10📘 EE Pocket Reviewer RojasEasy
In sizing of wire, this is
AManufacturing rule
BConstruction rule
CWiring design rule
DInstallation rule
#11📘 EE Pocket Reviewer RojasEasy
Partially protected locations under canopies, marquees, roofed open porches, and like locations, and interior locations subject to moderate degrees of moisture, such as some basement, some barns, and some cold-storage warehouse.
ADry
BDamp
CMoist
DWet
#12📘 EE Pocket Reviewer RojasEasy
A location not normally subjects to dampness or wetness. A location classified as ____ may be temporarily subject to dampness or wetness, as in the case of a building under construction.
ADry
BDamp
CMoist
DWet
#13📘 EE Pocket Reviewer RojasEasy
A system or circuit conductor that is intentionally grounded.
AGrounding conductor
BGrounded conductor
CGrounding electrode conductor
DGrounding equipment
#14📘 EE Pocket Reviewer RojasEasy
The minimum diameter of a steel ground electrode is
A10mm
B12mm
C14mm
D16mm
#15📘 EE Pocket Reviewer RojasEasy
For REE board examination, the passing general average is 70% provided there is no grade below ____ in any of the 3 subjects.
A50%
B60%
C65%
D40%
#16📘 EE Pocket Reviewer RojasEasy
What is the weight percentage of electrical engineering professional subjects?
A40
B35
C45
D25
#17📘 EE Pocket Reviewer RojasEasy
The ampacity of the fuse should be 125% of the continuous load current is covered by
AInstallation design
BWiring design
CManufacturing design
DConstruction design
#18📘 EE Pocket Reviewer RojasEasy
Generators ad motors should be dust proof is covered by
AInstallation design
BManufacturing design
CWiring design
DConstruction design
#19📘 EE Pocket Reviewer RojasEasy
A conductor used to connect equipment or the grounded circuit of a wiring system to a grounding electrode or electrodes.
AGrounding conductor
BGrounded conductor
CGrounding electrode conductor
DGrounding equipment
#20📘 EE Pocket Reviewer RojasEasy
The conductor used to connect the grounding electrode to the equipment grounding conductor to the grounded conductor, or to both, of the circuit at the service equipment or at the source of a separately derived system.
AGrounding conductor
BGrounded conductor
CGrounding electrode conductor
DGrounding equipment

More ESAS topics