Electrical Engineering · Question Bank

DC Circuits

52 questions · page 1 of 3. Answer in your head first, then check the solution.

DifficultyAll 52Easy 49Medium 3Hard
#1📜 EE Pre-Board August 2012📘 PowerhouseEasy
If one of the resistors in a parallel circuit is removed, what happens to the total resistance?
ADecreases
Bincreases
Cexactly doubles
Dremains constant
#2📜 EE Pre-Board August 2012📘 PowerhouseEasy
Four 100 W, 100 V heaters are connected in series across a 600 volt circuit. The total heat given off by the four heaters will be _ watts.
A900
B800
C400
D2000
#3📜 EE Pre-Board August 2012📘 PowerhouseEasy
If a 440 V heater is used on 110 V supply, heat produced by it will be as _ much.
A1/4
B4 times
C16 times
D1/16
#4📜 EE Pre-Board March 2013📘 PowerhouseEasy
Three 90 mH inductors are connected in parallel. Find the total inductance.
A270mH
B30mH
C45mH
D120mH
#5📜 EE Pre-Board March 2013📘 PowerhouseMedium
A certain copper wire has a resistance of 0.5 ohms when the length is 10m. What is the diameter in mils?
A57.3
B33
C29.4
D26
#6📜 EE Pre-Board March 2013📘 PowerhouseEasy
Two equal resistors when connected in series across a supply draw a total of 20 watts. What is the total power drawn when the two resistors are connected in parallel across the same supply?
A20 W
B40 W
C60 W
D80 W
#7📜 EE Pre-Board March 2013📘 PowerhouseMedium
A 16-ohm resistor is connected in series with parallel combination of three resistors, R and 48 ohms. Determine R if the power consumed by the parallel connected resistor is equal to the power consumed by the 16-ohm resistor.
A6 ohms
B12 ohms
C24 ohms
D36 ohms
#8📜 EE Pre-Board March 2013📘 PowerhouseMedium
The power consumed by a heating element made of copper wire is 250 W at 220 V and 30 °C. What is the power consumed by the same element at 220 V and 100 °C? The temperature coefficient of the element at 30 °C is 0.004 per °C.
A274 W
B233.33 W
C215.25 W
D196.31 W
#9📜 EE Pre-Board August 2013📘 PowerhouseEasy
If there are eleven resistors of 33kΩ each in parallel, what is the total resistance?
A363 kΩ
B3.3 kΩ
C3 kΩ
D16.5 kΩ
#10📜 EE Pre-Board August 2013📘 PowerhouseEasy
Suppose a cell of 1.5 V delivers 100 mA for 7 hours and 20 minutes, and then it is replaced. How much energy is supplied during this time?
A0.49 Wh
B1.1 Wh
C7.33 Wh
D733 mWh
#11📜 EE Pre-Board August 2013📘 PowerhouseEasy
A lead storage battery is rated at 12 volts. If the internal resistance is 0.01 ohm, what is the maximum power that can be delivered to the load?
A1,200 w
B1,800 w
C3,600 w
D7,200 w
#12📜 EE Pre-Board March 2014📘 PowerhouseEasy
Two 30 Ω resistances are connected in series. When an unknown resistance R is connected in parallel with one, the new total resistance is 40 Ω What is the value of R? 5Ω
A5 Ω
B15 Ω
C20 Ω
D25 Ω
#13📜 EE Pre-Board March 2014📘 PowerhouseEasy
In a parallel circuit the potential difference across the resistance
Avaries
Bis different from the applied voltage
Cis sometimes constant
Dis always constant
#14📜 EE Pre-Board March 2014📘 PowerhouseEasy
Four resistances of 10, 20, 30 and 40 ohms are connected in parallel. What is the equivalent resistance?
A100 Ω
B9.6 Ω
C3.6 Ω
D4.8 Ω
#15📜 EE Pre-Board March 2014📘 PowerhouseEasy
The potential at the terminals of the battery falls from 9 v on open circuit to 6 volts when a resistor of 10 ohms is connected across its terminals. What is the internal resistance of the battery?
A5 Ω
B4 Ω
C3 Ω
D2 Ω
#16📜 EE Pre-Board August 2014📘 PowerhouseEasy
An electric heater takes 1.2 kWhr in 30 minutes at 120V. What is the current input to the heater?
A20 A
B15 A
C10 A
D5 A
#17📜 EE Pre-Board March 2015📘 PowerhouseEasy
Two resistors \(R_1\) and \(R_2\) are connected in parallel. \(R_1\) is twice \(R_2\). If the current in \(R_1\) is I, what is the current in \(R_2\)?
AI
B2I
C4I
DI/2
#18📜 EE Pre-Board March 2015📘 PowerhouseEasy
The condition in Ohm’s Law is that
Aratio V/I should be constant
Bcurrent should be proportional to voltage
Cthe temperature should remain constant
Dthe temperature should vary
#19📜 EE Pre-Board March 2015📘 PowerhouseEasy
A bulb having a rating of 220 volts, 75 watts is to be connected to a 110 volts source. What power will it draw if connected across 110 volts source?
A37.5 watts
B9.375 watts
C75 watts
D18.75 watts
#20📜 EE Pre-Board March 2015📘 PowerhouseEasy
A load of 10 ohms was connected to a 12-volt battery. The current drawn was 1.18 amperes. What is the internal resistance of the battery?
A0.35 Ω
B0.17 Ω
C0.25 Ω
D0.30 Ω

More Electrical Engineering topics